top of page

MTX Audio, 4 channel Thunder amp

THUNDER75.4

in stock

MAIN FEATURES:

400W RMS

UPGRADE YOUR POWER FOR BETTER SOUND
You'll get some serious MTX musical mojo when you put the MTX THUNDER75.4 4-channel amp in your car. This compact amp will drive each of your front and rear speakers with 75 watts RMS of detail-enhancing musical power. Install a nice set of speakers, and you'll hear sounds you've never heard before, even in your favorite songs. And this little bruiser will truly fit in places where amps don't usually go

VERSATILITY
You can also put this amp into 2-channel mode to drive two subwoofers with 200 watts RMS per channel. In 3-channel mode, you can run some nice components up front with two channels while running a sub off the third channel.

ADVANCED TONE CONTROL
The crossover filters on the front and rear channels allow you to adjust the sound to your setup. The front channels use a variable high-pass filter to keep the bass away from your full-range speakers, so they play cleanly. The variable rear crossover can be set to high- or low-pass depending on whether you're running a subwoofer or full-range speakers on the rear amp channels. It also features a very wide range of crossover points, that'll be useful for tuning midrange and midbass speakers.

Specifications:

4-channel car amplifier
75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
200 watts RMS x 2 bridged at 4 ohms (4-ohm stable in bridged mode)
Frequency response: 15-25,000 Hz
Class AB amp technology
Variable high-pass filter on front channels (10-200 Hz, 12 dB/octave)
Variable high- and low-pass filters on rear channels (50-750 Hz, 12 dB/octave)
Preamp inputs
4-gauge power and ground leads and a 60-amp fuse recommended — wiring and hardware not included with amplifier
No onboard fuses — when installing multiple amps in a system, an additional 60-amp in-line fuse between the distribution block and the amplifier is recommended
12-5/8"W x 2-1/4"H x 6-5/16"D

bottom of page